Best posts made by wdenker

@phaedrux

@droftarts we figured it out. The bltouch had a small metal shaving in the pins from factory. Then the fans the config.g somehow didn't get copied over. So I got a little ahead of myself with this post.

@dc42 I sure would love to! I have a corexyuvab utilizing 4 leadscrews, two independent gantries and heads. Would love this capability.

Wondering if there is documentation I am not finding on idexx machines. I have my dual gantry dual head corexy printing and was wanting to start a dual head print in ditto mode. But I'm not finding the documentation on it.

@dc42 Has this changed at all? It would be nice to have it pause and only stop heating the heater that faulted not the bed. Can this be changed somehow? Also if it was a true pause instead of timing out and going away after so long would be awesome as well. Most of the time the print stops in the middle of the night and I don't wake up early enough to get to it. I don't see any reason for making it time out or having the other heater stop.

Wondering if there's a way to do baby steps for individual lead screws? I have a fairly large format printer I have four lead screws that I would like to be able to babystep individually. The mechanical leveling and mesh leveling doesn't get it as close as I would like.

@Veti you are right sorry I pulled from my 2.05 version. and 3.1 I only have working on duet 3 so far.

@phaedrux no but my infrared thermometer shows it is accurate.

@jay_s_uk ah you were right. We had to switch it to 5v vs 3.3 and didn't have it on in after we swapped to the 5v. So all of my issues are resolved at this point.