Topics created by mlaustin6

Hi All,

Doing some more research, I reworked the belt layout based on how duet firmware can support an IDEX setup in corexy format, which seems to be corexyu. I've added the belt connection points to the extruders in the CAD design. I've also made it more clear on the diagram how the belts route. Can someone please confirm this will work as designed?

corexy idex.png idex plan.png

I used my multimeter to check the thermistor, and it was good. I ended up redoing all the crimps on the heater line, and it is back up and running again. I did not see any loose connections. Maybe one of the connectors was bad. I replace the hotend with mini Tamiya connectors. Thanks for the guidance.

Does it get better with input shaping off?

Why no cooling fan? Why no pressure advance?

I just ran a print that was 4mm, and DWC showed 4.1. The layer height was .2mm, so there should have been 20 layers. It printed 21. When I remove the zhop from Slic3r, the file shows as 4mm.

I posted another thread here where I felt like my first layer is being smashed down. It apparently is because it is printing the first layer at .1mm and the rest at .2mm.

I would rely on firmware retraction, but the zhop is a bit too slow compared to Slic3r. I posted on the Prusa Slic3r forum, and the conclusion was that because the preview was showing the correct height it was not a Slic3r issue.

What could be causing this?

@Phaedrux
Hmm interesting. I ran M122 after a print finished.. I am on firmware 3.0.

Configuring pressure advance should eliminate the need for wipe anyway.

@mlaustin6 said in Cura 4 barely extruding:

I had it set to 1.75mm, and it somehow reverted back to 2.85.

If you use Cura long enough, this is bound to happen to you. Very common problem.