Posts made by mrenz999

@phaedrux
I will make that change.
Thank you

@phaedrux
6hc

@phaedrux
G31 P50 X16.795 Y25.4 Z.43
Tried P8 and P5
VCC DO AO are the three wires Red, Black, Blue in that order
I put them on the board Red to 5v Black to Ground Blue to In.
My assumption is the potentiometer changes the how sensitive
it is.

@mrenz999
Also, m119 gives this respons.
m119
Endstops - X: not stopped, Y: not stopped, Z: not stopped, Z probe: not stopped

@mrenz999
I guess I should mention firmware 3.4b7

I am using this probe I have as a backup. Other one broke and waiting for a replacement to come.
https://www.amazon.com/dp/B07V6GR72Q/ref=cm_sw_em_r_mt_dp_o8r7Fb4BMTP14

Duet 3 mainboard. Connected to io 3. Hot is connected to the 5v pin, Blue wire is connected to the In pin, black connected to ground.
M558 P5 C"io3.in" H5 F300 T6000

I have tried with an exclamation point in front of it and without. It shows at 1000 with the exclamation point and zero without. When I
tap it either way no changes or acknowledgement of that happening.
Where am I going wrong ?
lol

Thanks

@gloomyandy Will do. My heaters just turned off mid print. So no board reset.

@vrghost I had a similar issue. Did not reboot just stopped printing twice now. Once 3 mins in the second time 6 mins in. I checked on printer both times to find the heaters off, bed and tool, and it stopped. No errors reported just not printing.

@fcwilt I will answer for me. No, my issue was never resolved.

@fcwilt makes perfect sense. I will set that. Thank You

@fcwilt Not necessarily. I just want it to do multiple probes when it checks bed leveling when I home the printer.

I can but does that affect the bed leveling as well ?

@3DPrintingWorld I pulled screws out of all of them and started a retighten. Trying to see if something came loose.

@fcwilt Perhaps. I did print the tool but things move so I will recheck them.
Is there a way to add the a and s parameter to your bed.g when doing the leveling so it does multiple probes ?

@fcwilt gotcha. The are underneath

@fcwilt So the left one is in the middle of the bed on the X axis. The 2 on the right are at the corners of the bed frame. The bed frame sits on the attachment to the linear guide mounts

@fcwilt

@fcwilt Perfect. Thank you. Does it matter where in the M558 I put that ?

Yes thats the one Except I have 3 z motors. 2 on the right side and 1 on the left

@3DPrintingWorld In your bed.g do you have it do multiple probes per point ? If so how do you accomplish that ?