Topics created by Pierrelito

@Pierrelito I'd also avoid the use of

G1 H2 X-5 Y-5 F6000 ; move back 5mm

as well at that point your axis is homed so you can just use a normal (H0) move to back away from the endstop. H2 means use an individual motor move, which I'm not sure you want with a corexy printer.

To make it was due to the SBC, I configured the duet in standalone mode and everything worked.
I might need the sbc in the future.

@jay_s_uk I am using the latest update

Is the G-Code something like G1 A32.5?

You can post-process the script and change this command to M280 P0 S32.5...

Use M115 to check that you are running firmware 3.1.1 on the main board and 3.1.0 on the expansion board. Run M98 P"config.g" to check whether any errors are reported.

have you connected 24v to the out0 power in?

@deckingman Thank you very much for this document. Never saw it before, it will come in handy.