Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login
    1. Home
    2. Polyneutron21
    3. Topics
    • Profile
    • Following 0
    • Followers 0
    • Topics 5
    • Posts 20
    • Best 0
    • Controversial 1
    • Groups 0

    Topics created by Polyneutron21

    • Polyneutron21undefined

      Eddy current probe (duet SZP, Cartographer, Beacon)

      Hardware wishlist
      • • • Polyneutron21
      16
      -1
      Votes
      16
      Posts
      878
      Views

      elmoretundefined

      @Polyneutron21 Order link sent.

    • Polyneutron21undefined

      New SZP probe board has an internal short

      Order discussion
      • • • Polyneutron21
      2
      0
      Votes
      2
      Posts
      148
      Views

      Phaedruxundefined

      Please send an email to warranty@duet3d.com and CC your reseller. Include a link to this forum thread and the details of your original purchase. You'll receive a reply with a form to fill out.

    • Polyneutron21undefined

      Duet 3 1LC with Semitec 104NT-4R025H42G temperature Probe

      General Discussion
      • • • Polyneutron21
      2
      0
      Votes
      2
      Posts
      71
      Views

      Polyneutron21undefined

      The different B values where the key. I tried the probe on temp1 and it worked. The hot end tool board was 23,6°C which is now controllable. I checked the pin connectors and plugged it into Temp0 and after booting it up it works their as well. B values affect the reported temperature.

    • Polyneutron21undefined

      Duet 6HC 1LC core xy quad z motors misbehaving

      Tuning and tweaking
      • • • Polyneutron21
      2
      0
      Votes
      2
      Posts
      71
      Views

      jay_s_ukundefined

      @Polyneutron21 change the direction (S value on M569) on the z drivers going in the wrong direction

    • Polyneutron21undefined

      Scanning z probe problems

      Duet Hardware and wiring
      • • • Polyneutron21
      3
      0
      Votes
      3
      Posts
      127
      Views

      elmoretundefined

      Seems like another possibility is that the ribbon cable isn't fully seated, photos would be useful.