Topics created by specktech

After going through all my settings, I reformatted my SD card, And re-loaded all my setup files. After I probed the bed and was ready to run a test print. I went to wipe the nozzle on my Hemera. And it moved just a small amount. I instantly knew I just found the problem. I re-tightened my nozzle and have now printed about 40 hours no problems. Just love my Duet 2 wifi board. Have a great 2024 Duet3D.

@Phaedrux Thanks so much man. I really appreciate that info. Really proud to be using Duet 3D. You guys are awesome.

I assume this is in resolution to this thread?

https://forum.duet3d.com/topic/27836/duet-2-wifi-struggles-to-load-my-files/3?_=1647892453313

@specktech As I recall I had these issues with a Duet3 6HC and a firmware upgrade fixed it complete.

@specktech
just make sure the extension wires have the biggest diameter you can crimp the connectors to. And also make sure they are braided or twisted.
For sensors I had good results with shielded CAT5 network cable.

I got the Duet 2 wifi working again. So stoked. Thank you so much for those little tips. I really like the way this board works with my Ultimate XL. Big smiles Duet 3d.