Topics created by Trideo

@Trideo first suggestion would be upgrade to 3.4.4 and see if it happens again

@Phaedrux

I know it’s an old firmware, but the printer came with it and when asking the vendor regarding upgrading the message was that it should work, but he didn’t guarantee it.

So yes, I will definetely upgrade, but only if it is fixed. I read another post regarding resurrect issues and the conclusion was that that there were errors in the a t least a 2021 version of the firmware, and it had to be looked upon. I think I’ll ask the admin that answered that post whether it was ever fixed.

But thanks for your advice👍

state.status=processing maybe? That's different than the busy for homing.

@Trideo said in 4 Wires BLTouch Connection:

About BLTouch connector

I used the 5 pin version of this recently. https://www.aliexpress.com/item/4000708135064.html seems to fit both the genuine and cloned BL Touch, but the catches are just ever so slightly smaller so its not as secure as the genuine wire. Seems to be on par with the cloned though.

A dab of hotglue or silastic for peace of mind might be a good idea, or to get genuine JST parts from a repurable source..

Hi There,

We are currently running reprap Firmware V3.2, can we speak about this topic as meta command example?
It will be a useful for us! There is a C, C++ programmer in our team who can't wait to start playing with it!!

Best regards,

Simon

Hi @dc42 @Phaedrux @infiniteloop,

We tried to get a proper Z-offset value but, in some cases, due to thermal dilatation (between PLA at 30C chamber temperature and ABS at 90C) we need to use baby stepping. Did you find a solution to that issue ?

Thanks for your support,

Simon

Hi there,
Thanks @dc42 for answering.
We solved it! Using other stepper, same model, this one was not working well .... or we burned it making test.

Finely 2.V works well! M569 P10 S1 T3:3:5:0 works ENA +/- disconnected (Or use R parameter in M569)

Thanks!

Simon

@Trideo for more information about T-1 P0 (and tool commands with P0 in general) see:

https://duet3d.dozuki.com/Wiki/Gcode#Section_T_Select_Tool

You may find using P0 helpful to have as user macros in order to switch the active tool without running the tool change macro files so you can switch which IDEX head is active without having the heatup, purge or whatever else you do with your IDEX tool before you start heating.