@francescoita said in DWG drive configuration and Config.g not congruent:

When I make the home if the U axis arrives at the stall it also blocks the Z by not completing the home correctly.

Please start a new thread for this problem, and in it explain your configuration.

@martin1454 said in Duet Wifi - How to Set IP?:

@perseveranze This is normally done on your router you are connected to - Give the MAC address an reserved IP address, since it is the router that designates the IP (but the duet can request to have the correct IP, but might not get it)

I agree, a router IP address reservation is probably simplest.

Any ways, look at M552 https://duet3d.dozuki.com/Wiki/Gcode#Section_M552_Set_IP_address_enable_disable_network_interface

your command would be M552 S1 P192.168.1.xxx

M552 can only be used to set the IP address on Ethernet-enabled boards. On the Duet WiFi it is necessary to allow the IP address to depend on which network you are connected to, because the same IP address may not be appropriate on different networks. So the IP address is set in the M587 command along with the SSID and password.

Finally found time to upgrade to DWC 1.22.6 and can confirm that the behaviour persists.

In summary the "Heaters" section of DWC always shows active and standby temperature for Heater1 as being zero (with a multi extruder, single heater, hot end) .

It could be kind of dangerous as it is possible to set an active tool temperature in the heater section but not know that it has been set because the displayed value is always zero. It's not a problem if temperatures are always set using the "Tools" section of DWC.

Which firmware and DWC version are you using? I suggest you upgrade to the 2.02a firmware bundle if you are not running it already (RRF 2.02, DuetWiFiserver 1.22, DuetWebControl 1.22.6 unless you are running the DWC 2.0 RC).

@richardmckenna I recently erased my cache data and the new version of DWC came up. The machine is working however the motors are making more noise than originally. I do not know how to install stealth chop of spread. The notations across the Duet board us nnn to explain the variables. Is there a copy of the motor variables that I can dial in?

Thank you for the thorough explanation, and I did learn something cool!.

The tab thing makes sense.

The overlays/controls? They go away when I scroll... still, having them gone semi-permanently is quite nice.

Nifty!

Fans can be named too (sere the M106 link above), but I don't know whether named fans are displayed in DWC2 when they are thermostatically controlled.

@jacotheron oh, actually you are right, I should use the non mini file then, because I report a lot of problems with DWC2 to @chrishamm

Thank you!!

I got it working !

@danal ah, ok. I was serving it from the internal IntelliJ sever. Thanks

Cura grabs ports away from the Arduino IDE...

@webercreative I guess if the SD card was having trouble writing the transfers would time out.

@fma said in User-Defined Macros in 2 columns ?:

BTW, on DWC, could it be possible to let the folder open once the macro is clicked? For now, the folder automatically closes, which is annoying when I want to launch several macros from this folder...

Your idea is better, instead of making it a menu, it should be a section to expand, and stay open until you click on another section, and have that one stay open.

Maybe even open when you hover the mouse on top of it, this way you don't need 2 clicks