Also check in DWC that the version of DuetWiFiServer you are running is 1.23.

@dc42 Duh! Thanks.

@zapta said in incorrect print time estimates (S3D), layer count etc:

@dc42, I wonder, board developers like you and slicer developers like Cura, S3D and Slic3r are on both ends of the same gcode protocol. Are there forums or communication channels between the two groups? For example, to discuss standard representation of estimation metadata that slicers can pass to the boards.

If there are any such channels, I am not aware of them. Every slicer seems to use different metadata keywords, and they often change.

There's also a difference between RC and beta releases. Beta releases often include large changes and experimental features, so they are more likely to include bugs. RCs are intended to be close to what we ship as a stable release.

@aplanetrider well I bought DUET2 at matterhackers. It finally works. Just lost $180 on a first one, which is sad. Decided to not connect screen to it anymore to avoid burning again. Even not connecting the screen via normal USB anymore. Who knows how this board is built, documentation on that is very poor. But with that said, it works fine with web interface, screen is almost not needed.

If the duet is set to DHCP the router will have an IP assigned so you can check there, or if you want to define the up address that can be done in the config.g.

See https://duet3d.dozuki.com/Wiki/WiFi_disconnections_and_AJAX_timeout_errors.

Yes it makes sense Thank you

Thank you, finally!

Main firmware versions 1.18 and earlier on the Duet WiFi used a DuetWebControl.bin file. If your main firmware is 1.18 or earlier, you need to update it before you can run more recent versions of DWC. See https://duet3d.dozuki.com/Wiki/Installing_and_Updating_Firmware#Section_Upgrading_a_Duet_2_Wifi_to_firmware_1_19_or_later_from_1_18_2_or_earlier and https://duet3d.dozuki.com/Wiki/Installing_and_Updating_Firmware#Section_Upgrading_a_Duet_2_WiFi_or_Ethernet_to_firmware_1_21_or_later_from_1_20_or_earlier. Latest stable firmware is 2.02.

If you are already running recent main firmware (2.02 is recommended) then you can just upload the zip file through the Settings General page of DWC.

I haven't tried doing it myself but this is the link I found on their documentation page

https://duet3d.dozuki.com/Wiki/Filaments

thanks that work

actually i take that back, i can see how it is formatted now, just my browser was making them look weird. my bad

OK, thank you. I'll give it a try.