Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login
    1. Home
    2. Tags
    3. breakout board
    Log in to post
    • All categories
    • Steppenleguanundefined

      Stepper motor turns only in one direction

      Duet Web Control
      • driver z axis wiring breakout board duet 2 wifi external driver external stepper drivers • • Steppenleguan
      3
      0
      Votes
      3
      Posts
      497
      Views

      Steppenleguanundefined

      @alankilian I might have found the problem.
      I checked the resistances of the 5V signal wires
      from the breakout board to the stepper drivers again and I found one cable that has infinite resistance.
      It seems like it is one of the dir+- cables. So that would explain why the motor is running but cannot change its director.

      At first I was expecting it to be the crimps or the connectors, but it appears that even with new crimps the cable is corrupted.

      I'm checking in again in the evening and take a new cable, measure the resistances and hope that this solves to problem.

    • Gost101undefined

      Duet Wifi Closed Loop and Panel Due

      Accessories and Add-ons
      • breakout board closed loop help panel due setup wiring • • Gost101
      23
      0
      Votes
      23
      Posts
      1.7k
      Views

      alankilianundefined

      @gost101 That will be fine as long as you don't draw too much current for the 5 Volt supply or the connector you are using.

    • Fireghost2013undefined

      Solved Duet 2 Wifi Bltouch isn't working.

      Duet Hardware and wiring
      • duet 2 wifi bl touch breakout board • • Fireghost2013
      3
      0
      Votes
      3
      Posts
      326
      Views

      Fireghost2013undefined

      @droftarts
      Thank you, that was the problem, thank you very much you are amazing 😁

    • Inno 3Dundefined

      Solved z motors drives faster than the should

      Tuning and tweaking
      • breakout board • • Inno 3D
      3
      0
      Votes
      3
      Posts
      284
      Views

      Inno 3Dundefined

      @dc42 you are so right!!!

      I've set the wrong gear ratio.

      Now it's working!!!

      Thank you very much!!!

    • pinkmaroundefined

      Error when opening source files on KiCAD

      Duet Hardware and wiring
      • schematics kicad breakout board • • pinkmaro
      6
      0
      Votes
      6
      Posts
      1.0k
      Views

      T3P3Tonyundefined

      @pinkmaro V1.0 was an internal version. the version we shipped was 1.1. I have updated the KiCAD files and documentation on Github to say v1.1, however there are no changes to the design:

      https://github.com/T3P3/Duet/tree/master/Duet_Expansion/Expansion_Breakoutv1.1