Topics created by akrepsianka

i dont have multimeter but i will consider your suggestion and buy 30w of cartridge to be in safe area. i use silicone sock

There are lots of threads on fans.
Easiest options:

use all 24v fans if you have 24v PSU use all 5V fans if you can

Or search for buck converter/secondary PSU options.

Yes that looks current for a single PT100 sensor used to measure the hot end temperature.

thanks for the information

i have 3 printer with duet. so the best solution is to connect fan 0 connector all cooling fans. looks more easy and rigit solution 🙂

Ask for the board to be repaired or replaced under warranty. See https://www.duet3d.com/warranty.

So disconnect the hot end heater from the terminal block on the Duet, set your multimeter to read ohms, and use it to measure the resistance between the two wires.

still not perfect but i think it will work for now. i ordered 30 20 fan which is more powerfull i guess that will work much better

Can confirm, dc42.

now i fixed it. i just got wrong information from facebook group page of tevo little monster duet users. i did oppsosite. make z offset "0" and now its printing perfectly

Please send an email to info@duet3d.com and we will sort something.

2 alternative solutions:

1. Upgrade your firmware to 1.19 but read the upgrade notes first. Firmware 1.19 deploys and retracts the probe automatically

2. Wrap the G29 command in a macro with M401 and M402 commands around it, then run that macro.

İ just adjusted and its working. İ just wonder can you check my firmware to see if there is a mistake. Mainly i need help in termistor section!