Topics created by KevinO

when i run g32 or g29 or like when iam runing my macro of g1 z10 and G30 s-1 20 times...

mmh really suspicious.. using duetwebcontrol 2 there was no leadscrew correction but with using the old one there is one.. mh so for me it works i think iam also doing a print and the first layer looks okay.

maybe its because of the fast raising i dont know 😄 with the precision piezo i never had something like that.. I saw all the time those Values
0_1560881768016_IMG_2644.jpg

good Morning,

I just checked it through again and do not get it to control the Fan0 alone. Fan1 and Fan0 are always controlled. I connected the two fans via a 4-wire PVC cable, can it hang together?

does my config look good?

here is a video:
youtube

*Edit:
i changed to an other fan (other model) and now it works.. maybe its because those are the same fans?

if you can connect to http and get a 404 error you're missing Duet Web Control (DWC) files that should have been in the /www folder on your sd card.

But you can activate ftp and upload either the classic DWC or the 2.0 version to /www on your sd card.

This should give you a reference for what the SD card should have looked like: https://github.com/T3P3/Duet/tree/master/Duet2/SD Card Contents

thank you very much 🙂 i think there went something wrong during the update... i erased everything and did an clean install and right now iam on 2.02 and everything works fine 🙂