Topics created by aldiallo

@droftarts thank you

@Falcounet @Herve_Smith

Hi, Thanks for taking the time to reply, actually I ended up answering my question earlier a couple of hours ago and have been finishing the printer configuration. the cable in question if anyone else looks fo the info in the future is the filament sensor.

Concerning the RPI, I'll be running the printer with Klipper not with original firmware hence why the RPI is requiered in my case.

I now got everything working as expected including the filament sensor so all well and good; again appreciate your time replying, especially that it was a dumb prep error on my side when I starting labelling and unpluging the cables from the SKR.

Thanks for the feedback guys, I'll retune my slicer settings and see what comes out and use a temp tower to nail the ebst printing temps for the filament being used. I'm also considering moving from Simplify3D to either PrusaSlicer or SuperSlicer once I get the new settings nailed in.

@phaedrux

Hello,

Nothing at first sight, bed look flat to me but what I can say is that the first layer sticks better in the middle and back and also on the front right side, I'm a bit far on the left corner, so need to redo my manual bed level again. This is using the stock bltouch with the stock mount but not the stock glass bed as I replaced it with TH3D EzFlex smooth PEI and a magnetic base

Hello,

@Veti,

The SKR1.4 and yeah I read about the possibility of running RRF on it but as I'm already running the 6HC on my Ender 5 Plus and that I'm quite happy with it, I said to myself, go for it 🙂

A PanelDue + 4.3" screen + printed enclosure is approx. 80mm high and 145mm wide.

Which Duet are/will you be using? If it's a Duet 3 Mini then you can use a Mnii 12864 display.

Thanks again.

@FLoRo Check the wiring for the BLTouch, post your config.

@FLoRo said in Help needed - Installing Duet 3D 6HC in replacement of a SKR 1.4:

Should I double the wire to OUT0_input from the same power station ?

I'm not sure what you mean by this. OUT0_input should either have a direct connection back to the PSU intended to supply the bed heater, or a short jumper connection to the main VIN input right beside it.

thank you