Topics created by jottesman

@Phaedrux :
I solved my problem, I add the command M501 at the end of my config.g.

I use in my Duet2WiFi the firmware version 3, RepRapFirmware Configuration Tool v2.1.8.

I made the autotune in the BED and I add the Heater model parameters at the config-override.g.

Now it's working well, thanks for the support.
thank you for your support. I read your previous recommendations on the topic.

@dc42 Interestingly it did however I assumed you suspected that the values were either not applied / were overwritten.

It turns out there was already a line in the config file specifying the parameters that occurred later that where I had included the correct ones. This was overriding the values and seems to have been what was causing the issues.

Needs some testing to be sure but it seems likes its running smoothly again.

Signal strength of -73dBm is marginal for the WiFi module. Please see https://duet3d.dozuki.com/Wiki/WiFi_disconnections_and_AJAX_timeout_errors.