Topics created by StaticRed

@dc42 I dont use RRF on my duet currently i am trying out klipper. I think klipper has functionality for multiple neopixel on one board? Can you maybe name me the exact pin of the LCD Connector?

@del87 said in Stallguard detection not working:

What is the repeatability of sensorless parking with your parameters?

I dont look to the sensorless homing like to the preciese type of homing.

@dc42 Hey thank you for the quick answer. I have the latest Duet 2 Wifi I think and it already works fine with Endstops from the outside. So I will just send a High signal 24/7 and then say my Arduino to set the pin to low for a short duration and then back to High? What kind of duration can you recommend?

@dc42 i will test thank you

@dc42 seems like my thermistor has died randomly. Nevermind i will just by a new one and try it out.

@staticred that doesn't have input shaping enabled. you need to use a build from here https://forum.duet3d.com/topic/24116/rrf-3-4-input-shaping-preview-available?_=1626707371091
make sure you use the latest new build from DC42 (towards the end of the thread)

@staticred 24000

@dc42 thats no problem. I dont need the printer 24/7 i have other printers which can get the job done. I thank you for the advice.

@dc42 said in Accelerometer Usage:

@jbarros said in Accelerometer Usage:

What is the rationale behind this change?

It's normal that configuration commands when they succeed do not return a response. You can still get the details by sending M955 with no additional parameters.

Ok, I get that, I was assuming a response as seen on the other posts and as the accelerometer was ok I also never got an error message (lesson learned, try various situations)

Don't wan't to correct you but M955 needs the P parameter 😊

51b7b2a3-d293-44f2-bb7e-1498f65cdcb5-image.png

Glad you got it. A little manual nudging to get it stable is pretty common. The tuning algorithm is still being improved upon to better deal with the edge cases like very large beds or very high powered heaters or chamber heaters etc.

@phaedrux Yes i had the wrong fan selected there. I now changed it to my other fan it works fine.

@droftarts Ah yes thanks a lot man! It was i think the editor! A little bit of reading would have saved me so much time haha. Nevermind have a great day!

yep there was a sneaky little m300 in there. Thank you very much, now i wont get woken up by my printer again 😄

SOLUTION
@Veti yep it was that, thank you!

@Stephen6309 thank you changed it in my config, works now

@StaticRed might be that you had the firmware flavour set to Marlin instead of RepRap? I've found that doing that (at least in Prusaslicer) causes the slicer to put a bunch of acceleration values in the gcode file which are in the wrong units (so 60x too small)