Topics created by TheBasedDoge

@TheBasedDoge said in Slow upload and then failure.:

Well, I found necessary parts in my parts pile

Your soldering looks better than mine 😊 - Glad to hear that the mod worked for you👍

@thebaseddoge said in "Print again" button is missing?:

and the troodon has 1.25. the UI on both looks identical though.

Update it.

https://docs.duet3d.com/en/User_manual/RepRapFirmware/Updating_PanelDue

@zapta said in How to wire / setup Neopixel on the Duet 2 Wifi?:

@dc42, is it OK to Have two 60 led stripes fed in parallel from the duet signal out? Or any other serial / parallel "tree"?

Yes, assuming your have sufficient 5V power to run both strips.

Oh, i see. I always keep the duet tab opened and pinned so i guess I have never had it change.

Any possibility of showing the camera feed on the new DWC2 status page?

@TheBasedDoge said in Many issues after upgrading to 3.0 RC-12:

G29 S1 ;Load heatmap G28 G1 Z15.0 F7000 ;Move the platform down 15mm G92 E0 G1 F200 E3 G92 E0 G1 X150 Y150 F7000 ; Move Probe to middle of bed G30 ; Do a single probe

You've loaded the heightmap before you've done the G30. That's the problem.

It should have come with 2 jumper for the purpose, but if you have some spares laying around from a PC or other electronics device?

alt text

That one worked.

I still don't see anything that would add an additional 0.03 offset.

@dido8884 said in WiFi Issues - "Network Error" on uploading almost every file:

I had this situation because of the long file name.😲

From https://docs.duet3d.com/en/User_manual/Reference/Gcodes#filenames-and-paths

Full paths, including all directories and subdirectories are limited to 120 characters. e.g.:
0:/gcodes/0123456789/012.gcode
counts as 30 characters

Ian