The new heater tuning algorithm in 3.2 can take a long time. Just let it finish.

https://forum.duet3d.com/topic/19761/new-heater-tuning-algorithm

@Veti said in problem Set Mesh Parameters:

the G31 need to be correct or the mesh bed levelling will not work correctly.

I made a mark on the plate where I positioned myself above with the nozzle n ° 1 and then with the bltouch probe, I made the difference between the values indicated on the DRO

@Work-Horse-XL said in Problem with config working with Simplify on the Tool heater:

M584

as a side note observe the order
https://duet3d.dozuki.com/Wiki/Gcode#Section_M584_Set_drive_mapping

M584 must come earlier in config.g than any M350 and M906 commands. If it creates new axes, it must also be earlier than any M92, M201, M203, M208, M350, M566, M574, M667 and M669 commands.

It worked
Thanks

Thanks, it's fixed in the new version 3.1.8.

@Phaedrux Yes agreed. let me see how far I can get with the info and documentation you provided and I will get back to you

Thanks for the reply 🙂 I edited the config file and it's working now

Not currently. The forum is the main source of reporting and support. Issues are troubleshot and reproduced as possible and then escalated as needed where they are reproduced, tracked, and hopefully resolved internally.

In the near future we hope to have a github issue tracker up and running, however it would still be required to use the forum to attempt to troubleshoot the reported issues before being tracked on github simply because 99% of the time it's a configuration issue or misperception of how something should work.

Yes, I'd say you're right. Thanks for the report. Moved to the config tool forum for @chrishamm to take a look at for the next update.

Looks to be back online now.

Consider it reported.