@engikeneer thank you that sounds great. I am from germany

have image for correct mount? i have test with fan down effector, and if touch nozzle, led gren start, possible not have mount correct? Have see guide smart effector e not have idea error

thank you for the kind reply, much appreciated!

have a nice day/evening 🙂

https://duet3d.dozuki.com/Wiki/Duet_Wiring_Diagrams

@luca-f13 said in Duet Maestro with 12864 display:

@oliof said in Duet Maestro with 12864 display:

You will find the Duet Maestro Wiring Diagram on the Duet3d wiki. If you compare the pinout, you see that they differ. So at least the cabling needs to be redone.

But then, there are different 12864 controllers, and Duet only supports those based on ST7920 currently. I don't know if the Anet display uses ST7920 or something else.

omggggggg i'm stupid sorry
yes the cros of the cables was obvious to do but I have not absolutely thought about the processor I already understood everything thanks.
sometimes you have solutions under your nose but you don't see them 🙂

Sorry to reply to an old topic. But has someone figured this out? When I compare the pinout I see different names on the pins. Someone knows which LCD-pin has to be connected to which Maestro pin?

@paboman
Old thread but dropping in to confirm the following works for me:

SD > DUET
GND + GND > GND
5v > 5v
CS > SPI0_CS0
MOSI > SPI0_MOSI
SCK > SPI0_SCK
MISO > SPI0_MISO

Is that Duex5 genuine? It would appear not to me.

@Phaedrux they stopped working within an hour of being configured. I don't think the duex 5 ever worked.

@3dpnut said in Duet2 Wifi Driver 3 overheat issue:

Also, Drive 3 (the bad one) still gets hot.

you might be able to desolder the chip

@Kwad3d Ok Im Good. Sorry for the false alarm. It was all just a Typo error on my part holding me back

Just managed to using Heater 2 with thermistors 7 by adding X7 to M305.

The temperture reading looks fine, will double check the settings on M305.

It just a workaround solution, I still want to fix the E3 if possible.

@zapta yes, that's pretty much exactly what I was thinking. Spot on thanks!

Take a look at this thread: https://forum.duet3d.com/topic/16401/what-is-the-correct-mcode-to-restart-a-completed-print-job?_=1612197410123

Ok i will change this mosfet and try again thanks for your reply!!

As for the Z-probe, my current strategy is to traverse down to 100mm from expected bed and do a G30, that should cover any combination of tool and print bed so to say. However the M581 tap-test seem ingenious. Thank you!

But, using blowers instead of the BerdAir is one of my desired outcomes here, as I feel the berd is (compared to noise level) not the best way for a high flow hot end. I may be completely wrong here?

@bearer I ended up using these and so far so good. I appreciate the help. Thanks.

@Veti Thanks

Nice, thanks!

It's just an example. Build to suit.

@dc42 Thank you David!