@dc42
@rogerpodacter

I see theres confusion about the examples, as i mentioned this just examples (picked from the duet doku)
I can now share acutal accelerometer records.
Printer Type: CoreXY

Record no shaping:
IS_1.png

Based on what i learned here MZV should suits best in relation to curves
IS_2.png
No Shape with MZV curve:
IS_3.png
Shaped with MZV
IS_4.png
it looks for me pretty well shaped, except a bit the area arround 58Hz-78Hz
So my question that is now remain after i understand most of the whole thing (i guess so, if not correct me in my statements)
Is there any tweaking point on this?

After experimenting a bit i tried modified ZVDDD, if im right this one is lacking because it have a longer frequenzy and give me
almost the same result as MZV?
IS_5.png

excuse me again for not beeing clearly enough that i used examples

Edit: Is the MZV Shaper is automatically right on 40Hz, because its the highest peak and the first curve of the shaper, shapes this peak best?

@jay_s_uk said in Collecting LIS3DH data outside of RRF:

@t3p3tony you can't use previously collected data with the input shaper plugin

...although you could use it with the accelerometer plugin by uploading the .csv file to the sys/accelerometer folder.

@siam I was also missing the motor mapping assignment, which is a big bad omission. I was wondering why my Z-tower motor was in whining fibrillation mode for 30 seconds after a reset.

@chrishamm said in Lis3DH accelerometer with blutooth any good for SBC?:

At present RRF does the data collection and file saving.

...understood.
But it's the GUI that reads the file and does the calculations? It wouldn't matter then which device collects the data.