Topics created by CupaCabra

@Phaedrux said in 𝐏𝐫𝐞𝐬𝐬𝐮𝐫𝐞 Advance Problemes:

@CupaCabra said in 𝐏𝐫𝐞𝐬𝐬𝐮𝐫𝐞 Advance Problemes:

M203 X6000.00 Y6000.00

You're max XY speeds are fairly low for travel moves. Only 100mm/s. If your hardware is capable, you could try increasing this to allow for faster travels which may help with stringing a bit.

How much retraction are you using? What size nozzle?

Volcano hotends are quite difficult to tune due to their excellent melt properties. Pressure advance can only do so much. You may be able to reduce your printing temperature quite a bit due to this large melt zone. This may help keep it from drooling so much.

Agreed with those suggestions.

Also, how did you determine an S value of 0.75? I have a pretty short bowden and find that S1 - S1.4 is more appropriate. It just gets harder to tune all the motion control settings to allow that much pressure advance.

https://forum.duet3d.com/topic/5909/guide-for-posting-requests-for-help

Need more specific info please.

Now I read in the Doku. the right name of e2stop are exp.e2stop

Are the right code
M950 J1 C"^exp.e2stop”
M581 P0:3 S1 T0 C0

Thx, it works 🙂
Awesome

Pressure advance will be the next thing to tune and should help a lot.

https://duet3d.dozuki.com/Wiki/Pressure_advance

@CupaCabra said in BL-Touch don´t trigger by Home Z:

But if i try G30 Code the Z Move UP but the Pin don´t come Out.

Please post your deployprobe and retractprobe files.

Does the pin respond when you send M401 and M402?

@CupaCabra said in BLTouch Problem with Home Z:

P5

P9 is for bltouch

Try connecting the red wire to the centre pin on the Duet endstop connector, the white wire to the STP pin, and the black wire to the GND pin.

THX, the Boudrate was wrong 🙂 adjusted

now it´s works perfekt

I'm glad you got it fixed.