Topics created by patterson6

@patterson6 They're in stock, I think for a couple days stock ran out, but nearly immediately restocked. Could have signed up for restock emails?

Most, nearly all Volcano nozzles are in stock. Which materials/sizes are you wanting?

@jay_s_uk 3.4.4

@Phaedrux
I believe I'm back in business... Thanks

@patterson6 I've had good results with a high temp magnetic sheet and a ferro-sheet between cast-aluminum and 1mm thick FR2 print surface.
Makes it easier to remove prints, because the FR2 sheet really has a strong hold.
I recommend doing the same with your G10, if it's thin enough to be bend...

@patterson6 said in help with config.g:

M558 P5 R0.4 C"io3.in+io3.out" H5 F1200 T6000 ; set Z probe type to effector and the dive height + speeds
G31 P100 X0 Y0 Z4 ; set Z probe trigger value, offset and trigger height

What type of z probe do you have and have you measured the trigger height?

https://duet3d.dozuki.com/Wiki/Test_and_calibrate_the_Z_probe

Can you post an image of your heightmap display?

Ok, so that nightmare is over. I had time to come back to this project. I took the original sd card that came with the duet and plugged it in my pc just like last time and for some reason it let me look at the files. Last time it wanted me to format the card and i never did. So then i just dragged the sdiap_MB6HC.bin file into the folder where needed and that was it. Why that wanted to work all of a sudden i don't know.

Finished uploading the rest of the install in web control and is now 3.2.0.

Thanks for the help

if anyone is looking for a longer cord this 15 ft works for me

https://www.amazon.com/gp/product/B01GEDOR2S/ref=ppx_yo_dt_b_asin_title_o02_s00?ie=UTF8&psc=1