Topics created by Velvia

@deckingman That was the issue. Huge thanks!

@Velvia as @Phaedrux suggested, use the tool change files. You can put the M593 command in the tpost#.g file.

@droftarts This fixed it, thank you!
edited config.g to M671 X223:-30 Y0:0 S1

@achrnCan I use your files for my prusa Mk 2.5s? Would they work with a Super Pinda installed? thank

@Phaedrux Thank you for the help. Now I run as many times as I want, even with the Input Shaping plugin. No more crashes!

@Phaedrux Thank you!! I'm now on the right track, just need to fine tune it.

@joeko please start a new thread. This one is marked as solved, and your situation may be significantly different,

@velvia Sounds more like a pulley slipping, rather than a firmware issue. Check all pulleys are tight on the motor shafts. Otherwise

Ian

@velvia
If you want the fan to start at 30% at 40ºC, and increase till 100% when it reaches 65ºC could use something like this...

; Fan2 = MotherBoard Cooling ;----MCU & DRIVERS sensors------ M308 S3 Y"mcu-temp" A"MCU" ; create sensor for MCU temp M308 S4 Y"drivers" A"Drivers" ; create sensor for drivers temp M912 P0 S-0.8 ; Calibrate MCU temp M950 F2 C"fan2" Q500 ; create fan 2 on pin fan2 M106 P2 H3:4 L.3 B.5 X1 T40:65 ; Set fan 2 PWR fan. Turns on when MCU temperature, hits 40C and full when the MCU temperature reaches 65C or any TMC2660 alarms

@velvia print genrally looks clean to be wet material but it looks like wet material effects to me but if i had to bet its in the slicer my old cura use to do travel moves like richard simmons
usually a partialy wet roll gets better as it runs as the heats help dissapate the filament in que just being close to the heat more than it was off
also if it exrudes just in the air you should see if its wet or not the added backpressure (on the bed)would make it better not worse i usualy would see

@droftarts
It worked! Thank you!

@fcwilt @droftarts
Thanks for all the help!

alt text

@velvia The config.g file disappearing on save is an annoying and infrequent bug that we have been trying to chase down for a while, though have made progress on recently. See @chrishamm's post in this thread for an updated version of the firmware that may fix this issue: https://forum.duet3d.com/post/285788

Ian

@velvia said in Hotend temperature not rising at all:

@fcwilt Thank you for all the help!

Any time.

Frederick

@dc42
M119 gave me this:

M119 Endstops - X: at max stop, Y: not stopped, Z: not stopped, Z probe: not stopped

So I'll check the connections. Just figured it worked since the light is on and responds.

Edit: that was the issue. Crimping these tiny cables and connectors are annoying 🙃
Thanks everyone for your help! I have other issues as well (hotend not heating, hotend fan always on even though it has temperature control), but will make a new thread for those I guess.

Have you seen these?

https://docs.duet3d.com/en/User_manual/Machine_configuration/Configuration_linear_delta

https://docs.duet3d.com/en/User_manual/Tuning/Delta_calibration