@Yukikaze I confirm that this was not working in rc3. I have corrected the 3.5 source code and tested the fix. Thank you for reporting it.

Just confirming endstops work fine on 3.3V. I've wired the fans to a 12V fan socket. All working so far...

@Cognirit we've also integrated the scanning Z probe into our new Revo Roto Tool Board.

@Paddy That should be okay. For a list of Duet 2 WiFi/Ethernet pins and functions, see https://docs.duet3d.com/Duet3D_hardware/Duet_2_family/Duet_2_WiFi_Ethernet_Hardware_Overview#inputoutput

See also this thread where the Orbiter filament sensor is discussed: https://forum.duet3d.com/topic/34132/orbiter-filament-sensor-setup

Ian

@ageis https://www.antclabs.com/about

@fcwilt, agreed. I go down to 50% of my normal speed and small features are reduced another 50% (molasses in the high artic moves faster)

@roth the sensor just senses the angular position of the motor shaft. By itself, it doesn't provide closed loop control of the motor. So the sensor By itself isn't useful, it needs the 1HCL board to do the closed loop control.

The 1HCL board has its own processor, power regulators, CAN interface etc. and is capable of driving motors at up to 6A peak and 48V. It's really aimed at Nema 23 and Nema 34 motors driving larger machines, and I appreciate that it's rather expensive for use with Nema 17 motors.

@Phaedrux Not sure if it had to do with all the settings being redone or the firmware update but it is working now. Thank you!

@dc42

Thank you so much!

Solved

The CRTouch was fried and my code was bunk.

I’ll dedicate the first Benchy to you guys

@KenW Thanks. I think Ive found that mounting it to the side of the printer without a bowden tube was causing too many inconsistency issues. I stuck it right on the top of my matrix and it seems to be working consistently. It's just kind of bobble-heading right now though which Im not a huge fan of, I'll have to figure something out...

@dc42 sweet!!! crossing my fingers! thank you!

@Yukikaze thanks. I'll look at what would need to be done to make the file list menu item work in SBC mode.

@NZSmartie

Hi, any chance you could share your filament 1 macro?

Thanks

@Lakko you don't use the paneldue pins, it uses wifi
https://github.com/Duet3D/RepRapFirmware/wiki/JSON-responses

@OwenD Understood now, thank you.

@frnknstn518 said in klicky probe setup help:

i checked the wiring, and when connected lights are on. When i press the switch it goes off.

Which lights are on when the probe is connected, and go off when you press the switch?

What Z probe values does DWC report, when the switch is pressed and when it is not pressed?

Please send M558 with no parameters to check whether the configuration you provided was accepted.

@frnknstn518 said in klicky probe setup help:

M558 P8 C"!121.io2.in" X0 Y0 Z1 H3F200 T5000 ; K is probe type, P5 for NC switch, C input pin, H is dive height, F is probing speed, T is travel speed, A is number of probes

The comment says it is a NC switch, however you have used a ! at the start of the pin name, which would be correct for a NO switch.

Glad you got it sorted out. CRTouch is definitely a tricky one with the wacky wiring colors and no clear pinout and multiple versions.

@FLY

Any progress on this matter ??