@fcwilt said in Mesh probe grid not in defined range on Y axis:
Hi,
I downloaded your most recent posted config.g file and I still don't see a M584 command.
Perhaps there are defaults settings being used but I think it best to have an explicit command just to play it safe.
The noise you are hearing may be related to the speed of the move(s).
Frederick
I will add it. thx.
config.g:
; General preferences
G90 ; Send absolute coordinates...
M83 ; ...but relative extruder moves
M669 K1 ; switch to CoreXY mode
; Network
M550 P"HYPERCUBE_EVO_NGEN" ; Set machine name
M552 S1 ; Enable network
M586 P0 S1 ; Enable HTTP
M586 P1 S0 ; Disable FTP
M586 P2 S0 ; Disable Telnet
; Drives
M569 P0 S0 ; Drive 0 goes forwards (X)
M569 P1 S0 ; Drive 1 goes forwards (Y)
M569 P2 S0 ; Drive 2 goes forwards (Z)
M569 P3 S1 ; Drive 3 goes backwards (E0)
M584 X0 Y1 Z2 E3:4 ; Set drive mapping
M350 X16 Y16 Z16 E16 I1 ; Configure microstepping with interpolation
M92 X80 Y80 Z400 E820 ; Set steps per mm with 1/16 and BMG extruder with 0.9° stepper
M566 X1200 Y1200 Z60 E3000 ; Set maximum instantaneous speed changes (mm/min)
M203 X30000 Y30000 Z1000 E6000 ; Set maximum speeds (mm/min)
M201 X5000 Y5000 Z500 E10000 ; Set accelerations (mm/s^2)
M906 X1400 Y1400 Z1400 E1200 I30 ; Set motor currents (mA) and motor idle factor
M84 S30 ; Set idle timeout