@andreasMch In standalone mode you must query rr_reply as well if you need the G-code response. To know when a new response is available, you should monitor seqs from rr_model as documented in the documentation article.

@Tryptamine thanks for sharing!

@chrishamm
Perfect. Thank you!

@zBeeble Hello, I have a fix that I need to get put into place in DWC that will address this issue.

Is your SD card full?

@chrishamm That unfortunately didn't work for me. I ended up backing up my files and reflashing the SD card which ended up fixing the issue. Thanks.

I'm not super familiar with Orca slicer, but normally in if you leave out the temperature commands from your start gcode, the slicer will insert it's own using the temperature you've set in the settings.

Thank you’ll for your help. 👍👍👍

@TypQxQ that's a long write time on the SD card. I would suggest refreshing the SD card (don't forget to back everything up) or replace the SD card for a newer one

@oliof Thanks, I will try that out.

@droftarts That has solved the problem. Thanks for your help!

@oliof Ah thats a simple fix, opened a ingonito window and could see the correct version, thanks 🙂

@chrishamm Thanks for the help.

@Phaedrux will do! But… I can say it does remain because my E-stop isn’t hooked up to the duet but to the mains. In an emergency I want everything to stop. Full power cycle is on my list of standard troubleshooting approaches.

I haven’t had any issues since my last post and the only thing that’s changed is that I’ve commented out the line declaring DWC needs a password.

@gloomyandy Your advice is taken!

The old SD was 128MB in size, so probably not that fresh.

@chrishamm yes, I send the session key in the header, I also checked how the duet gui does it and I have the same

@Vinculum See https://github.com/Duet3D/RepRapFirmware/wiki/HTTP-requests#get-rr_thumbnail

@qurt The affected SBC is outdated and does not support rr_ protocol emulation yet. Upgrade it using apt and then try again. See https://docs.duet3d.com/en/User_manual/Machine_configuration/DSF_RPi#installing-updates

Also note that it would be better to use the native REST protocol in SBC mode unless you need to deal with boards in standalone mode, too. See https://github.com/Duet3D/DuetSoftwareFramework/wiki/REST-API for further information.

@droftarts so I was able to get the resume file to be created it just took some time for the capacitor to build a charge. Now the problem I have is with the offsets applied to make my print head square to the build plate the 0 position is off. When I press pause during a print it doesn’t return to limit switches it ends up coming up slightly short on X and Y.