I dont think so !
I have no T0 in Start Code or in my Config.g , because i use the e3d chimera+ and have set offset T0=-9mm / T1= +9mm.
and the bed distances goes from the mioddle of the chimera !
I havent change the startcode !
You could use MQTT4DSF to get information from your printer.
Its then just a case of getting that information to pushover.
You could use node-red as the dashboard to do so (this is the best way to install https://tech.scargill.net/the-script/). This has a plugin for pushover.
I just wanted to thank you for all your help!
It was my own bonehead mistake. I had originally used an knockoff BL and totally forgot that I had put the resistor across the signal to ground wires inside the harness.
Using my meter I finally figured out the issue with both ends unplugged.
I removed the resistor and it g28 and g29 perfectly!!
I was going out of my mind!