Topics created by ap742

https://docs.duet3d.com/en/User_manual/RepRapFirmware/Updating_PanelDue

@Adamfilip It shouldn't really matter since the compensation can go up or down, but it can help to match the Z homing G30 point to one of the probe points of the mesh.

filament-error is optional. Pause.g would be run if it's not present.

@dc42 after I asked the question I went to ready more and yah 😞 one day I learn how to read .. lol
I missed Upgrading ANY Duet 2 from 2.x to 3.0 or later requires installing 3.0 first.
anyway that did it . thank you for replying 🙂
I'm going to re do cable management-(have feeling it might have enough tension to do weird stuff and carriage and check bearings on my exoslids

@ap742 said in Ender 3 Pro driving past end stops after stopping:

had X&Y set to 1
changed it to 2 helped

I think you might have some problems with your motor directions still. I'm pretty sure the endstop locations on the Ender 3 are at the min position. IE to the left and at the back of the moving bed, so X0 and Y0. So unless you've moved the endstops I think you have larger problems. If they are at the low end, then your homeall movements need to flip directions. The actual motor directions should move -x to the left, +x to the right, -y moves the bed back (nozzle to the front) and +y moves the bed to the front (nozzle to the back.)

So it sounds like your coordinates are rotated 180 degrees with 0,0 in the back right corner and X and Y directions both flipped from "normal" orientation. That's fine, but you also need to take that account when measuring your probe XY offset and the M577 grid size.

@phaedrux Figured it out . it was wiring . originally I had it plugged in backwords into duet and instead of getting all the way in there and flipping I flipped them at the switch and signal pin was bad so I just re terminated all 3 and did the M591D with switch in and out and get Filament yes and now .. woooohooooo

Thank You good Sir

however. I went ahead and replaced thermistor with identical one - one from e3d
35034351-b491-4849-abd6-80468b67d2b7-image.png
and that's fine.

what I dont understand is - only thing thats changed is duet board and display
old setup was fine .

@phaedrux said in duet 2 wifi 3.2.2 bltouch height map way off:

Yeah, you already have it in your slicer start gcode after the homing is done, so that's a good place for it.
The heightmap would indicate there is some tilt. Is that not the case? Some manual leveling should take care of that.

Thank you so much for holding my hand.

@phaedrux You the man. Thank you good Sir!