Closing because lack of activity. Still experiencing this problem? Best to start over with a new thread.

@mfs12 said in Issue with PanelDUE 7" latest firmware:

@TheDragonLord BTW 3.3.0-rc4 is an outdated version of Paneldue Firmware. Please use 3.3.0 for any further tests.

i will, thanks

@gloomyandy : yes that was the error in 2 lines. 2 were ok.
Thank you 🙂

Thanks. I see pins that have the same labels now too, not sure how I missed that previously.

I decided to desolder the four-wire anyway to get more space for structure, so having done that I decided I may as well direct connect the wires. Seems OK.

@oliof Also a good idea!
Here is another thread about this problem...

Closed due to inactivity. Please re-test with recent version and start a new thread if needed.

Hey @redrout,

closing this thread due to inactivity. Please re-open if your issue persists with newer version of paneldue.

Hey @OwenD,

since 3.2.10 quite some changes were made to paneldue's firmware. please re-test the issue reported and open a new thread if your problem persists.

https://forum.duet3d.com/topic/24889/paneldue-3-4-0-pre1-released/6

@Aitor this issue should be solved with paneldue-3.4.0-pre1.

Closing this thread here, if you still experiencing problems, re-open or best to start a new thread.

https://forum.duet3d.com/topic/24889/paneldue-3-4-0-pre1-released/6

No feedback from the user. Closing and assuming issue got solved.

Closing due to inactivity.

@Aitor this issue should be solved with release paneldue-3.4.0-pre1.

I mark this issue as solved now. If you are still experiencing problems as described here either re-open this thread or start a new thread.

https://forum.duet3d.com/topic/24889/paneldue-3-4-0-pre1-released/6

Was afraid of that.. and certainly don't want to reinvent the wheel for something trivial. I was able to get it worked out another way. Thanks

@egon-net said in Macros not showing on control page after updating from 1.24:

But in "status" page are not shown, is that intended?

Yes, they are only displayed in the control tab.

Thanks for the feedback and help testing. Then this patch is ready for the next release.

Hey @Aitor , thanks for reporting back. It sounds very likely that it was related to the cable. Especially when it happens sporadicaly.