Is this a brand new board? When and where was it purchased?

When going through the link bearer provided check if any of the chips gets hot when using only USB power.

@Veti I will take a lol at that when I get home. My duet 2 WiFi connected fine though without this hassle before.

SOLVED, ran it through a switch and detected just fine. Also updated firmware but doubt that was it

There was talk to bring out a 6HC for external steppers. Any news about this @T3P3Tony ?

Alright, thanks! 🙂

https://duet3d.dozuki.com/Guide/Ender+3+Pro+and+Duet+3+Mini+5++Guide+Part+1:+Wiring/87?lang=en

Go through this to get connected with YAT. Duet3 should be the same as for the Duet2 Ethernet.
https://duet3d.dozuki.com/Guide/1.)+Getting+Connected+to+your+Duet/7

@Phaedrux said in Duet 3 - New user - few quires:

@Dan1990 said in Duet 3 - New user - few quires:

Btw: Should the Diagnostic LED blink all the time? I have Duet 3.
I have read that is normal but prefer to confirm

yes that is normal

We are labelling it STATUS on the next batch of boards instead of DIAG.

@Phaedrux I have sent off an email, yes.

Thanks @dc42 this has all really helped my understanding. I’ve massively appreciated all the help I’ve received.

@jay_s_uk Thank you! I don't know how I missed that. I don't even know when that got added, anyway that is it. I haven't finished my print but I will post back after confirming.

That took care of it, thanks again

Thanks for your help.

Double check your white wire as that one is the signal wire.

Is this a clone BLtouch or genuine? What version?

Ok thanks.

Thanks a lot Jay!

connect the signal to zprobe.in.

that is better because it has a higher tolerance.

at the moment you have 5v connected. that might not be enough to power the probe

Will check the voltage again...there was no reading the last time. I got the Duet3 working, but can't seem to get the UART on OI_1 to work with Arduino. Not sure what the issue there is....wiring is correct and the pin out appears to be sending a signal....wonder if the threshold voltage for reading is not quite there...might try a logic shifter

No it should be imperceptibly the same. the only time you'd want to increase the microstepping is if your steps per mm at x16 is incredibly low.

That's great news!

That's a good sign. It's pretty hard to kill a duet with a firmware update.