Topics created by grizewald

@chrishamm said in DWC 2 "Dark Theme" Cursor colour in editor:

Yes, absolutely. I'll change the cursor color to white in the next version.

Much appreciated! Many thanks.

Pleasure.

@T3P3Tony Nice one. 👍

I'll post in this thread if I see it again.

@grizewald nice!!

Indeed, how issues are handled is so much more important than weather or not issues can happen in the first place; and judging from the forum no one has any reason to expect less than what grizewald describes when problems do occur.

@phaedrux said in Does it matter if an axis is split over the Duet and a Duex?:

It doesn't matter. You just need to define which drivers belong to which axis. It would be typical to put all the Z axis on the expansion board just to keep them together and contiguous.

Thanks!

If it's just a matter of whether I can cope with consecutive or non-consecutive numbers, then it's not an issue.

I'm not sure yet how I'm going to put the two boards together and the wiring for the first two Z motors is already in place. While I might restructure a program to make sure that things are ordered in a coherent manner, I see no need to start lengthening wires unless I must.

D'oh!

My mistake, I assumed that as the codes were listed in hex, the value displayed would also be hex.

@grizewald said in Motor noise and print quality:

The 120mm/s section still appears to be the smoothest but the most obvious improvement is in the 60mm/s sections

mechanical (aside from the acceleration ringing) it looks ok to me now.
i think the difference in appearance now comes from the extrusion speed.
the faster you are printing the higher your hotend temperature needs to be.

After looking through the source code for the firmware, I don't find 0x20 in the ErrorCode enumeration either.

So why would errorCodeBits ever get that bit set? @dc42

Also, any ideas what would cause the output buffer starvation? The model being printed is tiny, but it does include lots of circles. Then again, I'm only printing it at 60mm/s and the circles don't have that many facets. I've attached the model for reference.

0_1565365509322_base.stl

All firmware is the latest versions from GitHub.

The fact that both the card supplied with the Duet, and a known good spare both exhibit the same problem would probably excuse the card, but I will give it a try with a brand new, straight out of the packet card, just in case. The Duet is certainly not having any trouble reading from either card as I'm having no problems printing files from them.

The router is no more than 2.5m from the Duet, which has the WiFi antenna sticking up out of a slot in its plastic housing. The devices are in sight of each other, so If -60db is too low then I suspect there might be something wrong with the Duet's WiFi board. I'll try removing the Duet from the case. I don't suspect green PLA to have any strange properties like completely de-tuning the WiFi board's antenna, but you never know with microwaves! 🙂