@OwenD Thanks ! 🙂 Your solution is awesome !

Post your config and tool files?

Also update to 3.2.2, including the tool boards.

SBC or standalone mode?

https://github.com/Duet3D/RepRapFirmware/releases/download/3.2.2/Duet2and3Firmware-3.2.2.zip

@AlVo94

No problem at all, glad you're up and running.

Instead of S255 please try S1.

Post your full config.g as well if that doesn't work.

@simonJ Follow the 'getting connected' guide, specifically here: https://duet3d.dozuki.com/Guide/1.)+Getting+Connected+to+your+Duet/7?lang=en#s9

Usually, I find it more reliable to turn off WiFi with M552 S-1, then turn it on in idle mode with M552 S0 before adding SSID, if there's no existing WiFi connection. Then send M552 S1 to enable WiFi.

Ian

@Saurabh said in Using FAN Pin as a GPIO in Duet 3:

Solved the issue, GPIO pin is working when a device is connected to that. Earlier I was checking output on out4 using a multimeter and it was showing almost 0V. Any idea how to detect this pwm signal on out4 using a multimeter or scope?

Connect a pullup resistor between the OUT- pin and the adjacent positive supply pin.

I have sent the warranty contact formular a few days ago, has it arrived? I didn't get a confirmation email yet or any other reply.

@TomasL said in Multiple problems:

Now, I got it working so far.
It seems that the IR-probe stopped to work though.
Well a minor problem.

Please start a new thread if you need help with that.

@Phaedrux Well it seems to have worked this time. I might have used the wrong settings when i used the config tool. It does say this:

Warning: heater behaviour was not consistent during tuning
Auto tuning heater 0 completed after 3 idle and 25 tuning cycles in 2864 seconds. This heater needs the following M307 command:
M307 H0 R0.322 C440.5 D3.78 S1.00 V24.1
Send M500 to save this command in config-override.g

No errors when heating the bed so can I assume that things are all fine then?

@Phaedrux I received my replacement board and now everything works properly. Thank you!

@dc42 said in Print last file:

{job.lastFileName}.

@MauriceM that is from the object model and will be automatically updated to whatever the last job was.

https://duet3d.dozuki.com/Wiki/Object_Model_of_RepRapFirmware

it makes no sense to buy a maestro and replace the drivers.

one of these ports with the port makes more sense.
https://teamgloomy.github.io/supported_boards.html

Ha ha!

I've done things like that also.

When I really try, I can get a USB keyboard plugged into the HDMI connector on my laptop.

@Dizzwold said in Considering Duet3, New to RPi:

What's the preferred method of transferring files from a Mac to the RPi ?

It's a full fledged linux desktop so you can use SMB to access file shares on other computers as well.

But for any Duet related files like config or macro files you can use the DWC web interface from a browser on your mac.

there is a beta of 3.3 that allows you to do tuning on the toolboard

@felek You made my day.

Thanx to all !!

see
https://duet3d.dozuki.com/Wiki/FAQ#Section_M307_Heater_1_appears_to_be_over_powered_If_left_on_at_full_power_its_temperature_is_predicted_to_reach_521C

if it is zmax already, tools are far enough to the buildplate, why need such stupid logic.

Thank you

Glad to hear.